BMR designed the ELK006 rear sway bar end link kit for street performance, autocross, and road race applications. BMRs heavy-duty adjustable end links are designed to reduce deflection normally seen with stock sway bar end links. End link deflection means reduced sway bar rate, leaving you with increased body roll and reduced handling ability. BMRs ELK006 will not deflect, giving you the full potential of the sway bar no matter how hard you drive. The adjustable links allow for sway bar height adjustability, giving you the ability to easily correct sway bar geometry and working angles on lowered Fifth Gens, as well as cars with adjustable sway bars. The ELK006 adjustable end links give you the ability to preload the sway bar to fine-tune your suspension setup for any track. Combine this with BMRs adjustable sway bars, and you can dial-in your car for the street or any track you may drive on. When performance is a must, rely on BMR's suspension!BMR's suspensions ELK006 rear sway bar End Link Kit is available in a durable black finish for long-lasting good looks. Installation time is about 1 hour. Proudly made in the U.S.A.! NOTE: compatible on 2012 models only when used with 2010/2011 style rear sway bars.. The amount of force exerted on the sway bar end link is staggering especially if you've upgraded to an aftermarket sway bar, like BMR's suspensions SB017. The stock end links are weak and can bend or break. BMRs ELK006 rear End Link Kit allows you to push your 2010-2011 Camaro to the limit without fear of end link deflection. BMR manufactures the ELK006s out of CNC-machined billet aluminum. The ball joint-style tie rods are manufactured by Proforged and offer huge advantages over other companies end links that use rod ends. Ball joints allow for more articulation than a rod end, which is what you want when you hit the track. This ensures long life and flawless operation, and they make less noise than rod ends. The ball joints attach to the sway bar with 12mm studs, while the ball joints attach to the end link tubes with -inch studs. This combination of components gives you a huge increase in strength over stock end links.. BMR's heavy-duty adjustable end links are designed to reduce deflection normally seen with stock sway bar end links.. Allows for proper sway bar working angles and geometry on lowered Camaros. Designed for street performance, autocross, and road race applications. Allows for preloading of sway bars to fine-tune suspension setup. BMR 10-11 5th Gen Camaro Rear Sway Bar End Link Kit - Black. Dramatically reduces sway bar end link deflection. Designed to withstand high compression loads. 12mm/1/2-inch studs for increased strength. Sway Bar End Link Kit, Set Of 4, Rear. Fits all 2010-2011 Chevrolet Camaros. Proforged ball joint-style tie rods. Suspension Stabilizer Bar Link. Proudly designed in the U.S.A.. Heavy-duty steel construction. Proudly made in the U.S.A.. 1-hour installation time. BMR Suspension - ELK006. Sway Bar End Links. Fully CNC-machined. Adjustable

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov