Hard launches from high horsepower cars at the drag strip require more than just a normal street-style sway bar. BMR's suspensions Xtreme Anti Roll Bar for 1982-2002 GM F-body allows you to launch harder without excessive body roll limiting traction, with little sacrifice to your Camaros street manners. Manufactured from heavy-wall 1.375-inch DOM tubing, BMRs Xtreme Anti Roll Bar (XSB001) is designed to eliminate body roll and transfer as much power as possible to the rear wheels. The XSB001 attaches to your F-body with polyurethane bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing under high compression loads. BMR's suspension designed the XSB001 sway bar for street performance and drag race applications. The large adjustable sway bar has two positions, giving you the versatility to drive to and from the track with the same sway bar. The XSB001 gives you a massive increase in rate over the stock bar (depending on year and model). These rate increases and adjustability allow you to almost eliminate body roll so you can leave the starting line harder with maximum traction. The hollow design gives you loads of strength without adding a lot of weight. When performance is a must, rely on BMR's suspension!BMR's suspensions XSB001 anti roll bar is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!. BMR Suspension designed the XSB001 anti-roll bar for drag race and limited street applications.. BMR 82-02 3rd Gen F-Body w/ 3.0-3.25in Axles Rear Hollow 1.375in Xtreme Anti-Roll Kit - Red. Massive increase in sway bar rate over stock sway bar (depending on year and model). Manufactured from 1.375-inch heavy-wall DOM tubing for increased strength. Xtreme Anti-roll Kit, Rear, Hollow 1.375", 3" Or 3.25" Axles. Designed for street performance and drag race applications. Adjustability allows for fine-tuning of suspension. Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit. Cold formed to better resist torsional fatigue. 88-durometer, greasable polyurethane bushings. Two-way adjustable for street and track use. Dramatically reduces body roll. Proudly designed in the U.S.A.. Fits 3" and 3.25" axle tubes. 1-2-hour installation time. Proudly made in the U.S.A.. Durable powdercoat finish. Fits 1982-2002 GM F-body. BMR Suspension - XSB001R. 100% bolt-in design. Anti-roll Bar Kit

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov